Seepex Macerator 110 Series, Not Binding Operating And Assembly Instruction

Page: 29 / 111

24
Disassembly /
Re-assembly
Ausgabe
issue
A / 26.07.1999
Dokument
document
OM.CHD.04e
Blatt
sheet
2 (3)
Adjust the bearing with lock nut (106) without
clearance / pre-clamping and lock it with a new
locking plate (107). Fill the external bearing area A
and B with grease 1).
2.3
Shaft Sealing (SEA)
Assembly of the shaft seal (SEA) as described in
document OM.SEA.__.
2.4
Shear Plate (900)
Burr and clean the seat-engaging surface in the
bearing housing (100).
Installation position of the shear plate (900) with
grooves as illustrated (detail X).
2.5
Headstock (905)
2.5.1
Adjustment of the distance between knives
A - Slip ring (380), fitting discs (112) with a total
thickness of 3 mm (dimension "P"), headstock
(905), conical unit (909) must be slipped on the
drive shaft (102). Screw down with hexagon nut
(M20 / not self-locking and no component of the
headstock assembly). Do not use the self-locking
hexagon nut (142), because this hexagon nut can
only be used once for the re-assembly acc. to
Point 2.5.3.
B - Measure the distance between the knife "C" in the
headstock (905) and the shear plate (900) using a
thickness gauge.
C -Dismantle the headstock (905) again.
D -Reduce the fitting disc (112) in such a way that the
distance between the knife "C" in the headstock
(905) and the shear plate (900) is 0,05 mm up to
max. 0,2 mm (dimension "M").
E - Repeat the assembly "A" with reduced fitting discs
(112) as ascertained in "D" and check the distance
between knife and shear plate as follows:
E1- CAUTION
The knives in the headstock (905) must not touch
the shear plate (900), because of danger to
destroy knives and shear plate.
F - Dismantle headstock (905) again. Continue
assembly acc. to Point 2.5.2.