Seepex Macerator 110 Series, Not Binding Operating And Assembly Instruction

Page: 86 / 111

25
9
Dismantling / Reassembly
Ausgabe
issue
B / 08.05.2013
Dokument
document
OM.CHD.02e
Blatt
sheet
3 (4)
Installing shaft seal (SEA)
Assembling shear plate (900)
Installing headstock (905)
Preparing headstock (905) for assembly
Correcting the distance between headstock (905) and shear plate (900)

Fill outer areas of bearing A and B with
grease.
– Refer to maintenance document
(

chapter 7.0) for grease filling
grade.

Insert shaft seal (SEA) .
– Follow instructions in shaft seal
dismantling/reassembly document
(

chapter 9.4).

Deburr and clean the contact surface on
bearing housing
(100) .
– Note fitting position of shear plates
(900) (detail "X").

Install shear plate (900) on bearing hous-
ing (100) with screw fitting (906, 907) .
CAUTION
E2 Irreparable damage to cutter and shear plate.
Damage to property can occur.

Cutter in headstock (905) may not come into contact with shear plate (900) .

Push fitting discs (112) with 3 mm total
thickness (dimension "P") and headstock
(905) onto drive shaft (102) .

Install headstock (905) and conical unit
(909) with hexagon nut (142) .

Check dimension "M" between cutter in
headstock
(905) and shear plate (900) .
– Use feeler gauge (WF) .

If the distance between the headstock
(905) and the shear plate (900) is not be-
tween 0.05 mm and 0.2 mm (dimension
"M"), refer to the following section.

Remove hexagon nut (142) .

Remove conical unit (909) and headstock
(905) .

Reduce fitting discs (112) .