Seeing Machines Guardian Gen 2, Field Support Manual, Page: 72 / 101

At the fuse box
Fuse holders are to be attached in line
with the power connection on the battery
and ignition wires
Various ring terminals can be used
depending on the connection type.
For further information on crimping
techniques refer to the “Installer
Resources ” on the TCP
Types of Connection:
The packaging comes with all crimps to
enable the installer to crimp together the
connections;
If you prefer soldering, that is also a
preferred method, be sure to protect your
soldering joints from shorting out with
electrical tape, heat shrink etc.
Ensure the fuse holders are installed at
the beginning of the power cable to avoid
potential shorts later in the line
Terminals Picture
Battery fuse is 7.5A mini blade fuse
Ignition fuse is 7.5A mini blade fuse
Before power connection
isolate the vehicle
The wiring is as follows;
RED WIRE – Battery Terminal
YELLOW WIRE - Ignition Terminal
BLACK WIRE – Ground/Chassis Terminal
Important Points to Note:
Make sure the vehicle is isolated before performing the power connection