Seat Ateca 2018, Owner'S Manual

Page: 136 / 412

Operation
It does not matter where you carry the key,
for instance whether it is in your jacket pocket
or in a briefcase.
Once the doors have been locked, they can-
not be opened again immediately. This will
enable you to check that the doors are prop-
erly closed.
If you wish, when unlocking, you can unlock
only the corresponding door or the entire ve-
hicle. The necessary adjustments can be per-
formed in vehicles with a driver information
system
›››
 page 36 .
General information
If a valid key is in the proximity of the car,
›››
Fig. 139

the Keyless Access locking and
starting system gives the key entry as soon as
one of the sensor surfaces on the door han-
dles is touched or the
softtouch /handle on
the rear lid is operated. The following features
are then available without having to use the
vehicle key actively:
●
Keyless Entry: unlocking the vehicle using
the handles of the front doors or the soft-
touch /handle on the rear lid.
● Keyless Exit: locking the vehicle using the
sensor of the driver or passenger door han-
dle.
●
Easy Open: opening the rear lid moving one
foot below the rear bumper.
● Press & Drive: keyless starting of the engine
with the starter button
›››
page 241 .
The central locking and locking systems op-
erate in the same way as a
normal locking
and unlocking system. Only the controls
change.
Unlocking the vehicle is confirmed with a
double flash of the indicator lights; locking by
a single flash.
If the vehicle is locked and then all doors and
the rear lid are closed leaving the last key
used inside the vehicle and none outside, the
vehicle will
not lock immediately . All the ve-
hicle's indicator lights will flash four times .
The vehicle will lock after a few seconds if
you do not open any door or the rear lid.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to open
any door or boot hatch.
Unlocking and opening the doors (Key-
less-Entry)
●
Grip one of the front door handles. In doing
this, the sensor surface
›››
Fig. 140
A
(arrow)
on the handle is touched and the vehicle un-
locks.
●
Open the door.
On vehicles with selective opening or info-
tainment system configuration, pulling the
door handle twice will unlock all doors.
In vehicles without safety system
“Safelock”: closing and locking the doors
(Keyless-Exit)
●
Switch the ignition off.
● Close the driver's door.
●
Touch ( once ) the locking sensor surface
B
(arrow) on one of the front door handles. The
door that is used must be closed.
In vehicles with a safety system
“Safelock”: closing and locking the doors
(Keyless-Exit)
●
Switch the ignition off.
●
Close the driver's door.
●
Touch ( once ) the sensor surface
B
(arrow)
on one of the front door handles. The vehicle
locks with the “Safelock” security system
›››
page 137 . The door that is used must be
closed.
●
Touch ( twice ) the sensor surface
B
(arrow)
of one of the front door handles to lock the
vehicle without activating the “Safelock” se-
curity system
›››
page 137 .
Unlocking and locking the boot hatch
When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity
›››
Fig. 139

.
Open or close the rear lid normally .
134