Seat Ateca 2018, Owner'S Manual

Page: 116 / 412

Operation
The symbol
lights up or flashes (in part accompa-
nied by audible warnings). Operating
faults or the lack of operating fluids can
cause damage to the vehicle or a fault.
Check the faulty function as soon as
possible. If necessary, seek professional
assistance.
It provides informa-
tion about processes in the vehicle.
Note
● Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as
well.
●
If there are several warnings at the same
time, the symbols will be displayed one af-
ter the other for a few seconds. The sym-
bols will stay on until you remove the
cause.
●
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
Priority 2 warning (yellow).
Information message.
Fatigue detection (break recom-
mendation)*
Fig. 126 On the screen of the instrument pan-
el: fatigue detection.
The Fatigue detection informs the driver when
their driving behaviour shows signs of fatigue.
Function and operation
Fatigue detection determines the driving be-
haviour of the driver when starting a journey,
making a calculation of tiredness. This is con-
stantly compared with the current driving be-
haviour. If the system detects that the driver is
tired, an audible warning is given with a
sound and an optic warning is shown with a
symbol and complementary message on the
instrument panel display
›››
Fig. 126 . The
message on the instrument panel display is
shown for approximately 5 seconds, and de-
pending on the case, is repeated. The system
stores the last message displayed.
The message on the instrument panel display
can be switched off by pressing the

button on the windscreen wiper lever or the
button

on the multi function steering
wheel
›››
page 122 .
The message can be recalled to the instru-
ment panel display using the multifunction
display
›››
page 112 .
Conditions of operation
Driving behaviour is only calculated on
speeds above about 65 km/h (40 mph) up to
around 200 km/h (125 mph).
Switching on and off
Fatigue detection can be activated or deacti-
vated in the Easy Connect system with the

/ button and the SETTINGS function but-
ton
›››
 page 36 . A mark indicates that the
adjustment has been activated.
System limitations
The Fatigue detection has certain limitations
inherent to the system. The following condi-
tions can limit the Fatigue detection or pre-
vent it from functioning.
●
At speeds below 65 km/h (40 mph)
● At speeds above 200 km/h (125 mph)
●
When cornering
●
On roads in poor condition
114