Driver assistance systems
●
The reverse gear must not be engaged.
●
The vehicle must not be on a very steep
slope.
The system can interrupt the Start-Stop
mode frequently for different reasons.
The engine does not switch off
Before the stopping phase, the system verifies
whether certain conditions are met. The en-
gine
does not
switch off, in the following sit-
uations for example:
●
The engine has not yet reached the mini-
mum required temperature for the Start-Stop
mode.
●
The interior temperature selected for the air
conditioner has not yet been reached.
●
The interior temperature is very high/low.
●
Defrost function button activated
›››
●
The parking aid* is switched on.
●
The battery is very low.
●
The steering wheel is overly turned or is be-
ing turned.
●
If there is a danger of misting.
●
After engaging reverse gear.
●
In case of a very steep gradient.
The indication
is shown on the instrument
panel display, and in addition, the driver infor-
mation system* shows,
.
The engine starts by itself
During a stopping phase the normal Start-
Stop mode can be interrupted in the following
situations: The engine restarts by itself with-
out involvement from the driver.
●
The interior temperature differs from the
value selected on the air conditioner.
●
Defrost function button activated
›››
●
The brake has been pressed several times
consecutively.
●
The battery is too low.
●
High power consumption.
Additional information related to the auto-
matic gearbox
The engine stops when the selector lever is in
the positions P, D, N and S, in addition to when
in manual mode. With the selector lever in po-
sition P, the engine will also remain switched
off when you take your foot off the brake
pedal. In order to start the engine up again
the accelerator must be pressed, or another
gear engaged or the brake released.
If the selector lever is placed in position R dur-
ing the stopping phase, the engine will start
up again.
Change from position D to P to prevent the
engine from accidentally starting when
changing and passing by position R.
Additional information about vehicles with
Adaptive Cruise Control (ACC)
In vehicles with ACC function, the engine will
start up again in certain operating conditions
if the radar sensor detects that the vehicle
ahead drives off again.
WARNING
●
Never switch the engine off until the vehi-
cle is stationary. The brake servo and pow-
er steering functions will not be completely
covered under warranty. More force may
also be needed to turn the steering wheel
or to brake. As you cannot steer and brake
in the normal manner, there is a greater risk
of accidents and serious injury.
●
Never remove the key from the ignition if
the vehicle is in motion. Otherwise, the
steering could lock making it impossible to
steer the vehicle.
●
To avoid injury, make sure that the Start-
Stop system is switched off when working
in the engine compartment
›››
.
CAUTION
The Start-Stop system must always be
switched off when driving through flooded
areas
›››
.
Note
●
In vehicles with an automatic gearbox,
you can control whether the engine should
»
271
Summary of Contents for Ateca 2018
