Operation
beam when passing through a town, for ex-
ample.
Switching the main beam assist on and off
Func-
tion
Use
Activate:
– Switch the ignition on and turn the light
switch to position
.
– From the base position, move the main
beam and turn signal lever forwards
. When the warning lamp
is displayed on the instrument panel dis-
play, the main beam assist is switched
on.
Deacti-
vate:
– Turn the light switch to a different posi-
tion to
.
–
OR:
with main beam on, move the turn
signal and main beam lever backwards.
–
OR:
move the turn signal and main
beam lever forward to manually enable
the main beam. The main beam assist
will then be deactivated.
Malfunctions
The following conditions may prevent the
main beam headlight control from turning off
the headlights in time or from turning off alto-
gether:
●
In poorly lit towns with highly reflective
signs.
●
Other insufficiently lit road users (such as
pedestrians or cyclists).
●
On tight bends and steep slopes (bumps)
and when oncoming vehicles are partially
obscured.
●
When the drivers of other oncoming vehi-
cles (such as a truck) can see over a guard
rail in the centre of the road.
●
If the camera is damaged or the power
supply is cut off.
●
In fog, snow and heavy rain.
●
With dust and sand turbulence.
●
With loose gravel in the field of vision of the
camera.
●
When the field of vision of the camera is
misted up, dirty or covered by stickers, snow,
ice, etc.
WARNING
The convenience features of the main
beam assist should not encourage the tak-
ing of risks. The system is not a replace-
ment for driver concentration.
●
You are always in control of the main
beam and adapting it to the light, visibility
and traffic conditions.
●
It is possible that the main beam head-
light control does not recognise all driving
situations and is limited under certain cir-
cumstances.
●
When the field of vision of the camera is
dirty, covered or damaged, operation of
the main beam control may be affected.
This also applies when changes are made
to the vehicle lighting system, for example,
if additional headlights are installed.
CAUTION
To avoid affecting the operation of the sys-
tem, take the following points into consid-
eration:
●
Clean the field of vision of the camera
regularly and make sure it is free of snow
and ice.
●
Do not cover the field of vision of the
camera.
●
Check that the windscreen is not dam-
aged in the area of the field of vision of the
camera.
Note
Main beam and headlight flasher can be
turned on and off manually at any time with
the turn signal and main beam lever
›››
152
Summary of Contents for Ateca 2018
