Scott 10,000, Instruction Manual

Page: 137 / 323

4 Maintenance
4--30
C9999--2 Issue 1
Poor Plastic Registration
Correct Plastic Registration
Fig. 4-42. Plastic Registration
Step: 2. Jog both sheets together to insure plastic
registration is good.
Step: 3. Flip one sheet over, then jog both sheets
together. The plastic on the reversed
sheet should back up to the plastic on the
other sheet. If this is not achieved,
perform feeder adjustment in Step: 4.
through Step: 6.
Step: 4. Remove locking screw that retains nut in
the side plate of the feeder. Do not lose
washer located behind shoulder of
locking screw.
Step: 5. Rotate nut clockwise to move plastic
toward middle of paper. Rotate nut
counter clockwise to move plastic toward
end of sheet. Make sure washer is
located between nut shoulder and plate.
Step: 6. Adjust feeder forward or backward until
the two sheets can run through machine
with the plastic properly backing up
reversed sheet.
Step: 7. Repeat Steps 1, 2, 3, 4 and 5 until the
plastic is properly centered.
Step: 8. Reinstall locking screw and tighten.