Scott 10,000, Instruction Manual

Page: 74 / 323

3 Operation
3--34
C9999--2 Issue 1
BAD CUT
HIGH
TOPPING
Fig. 3-70. Test Sheets
Step: 8. Run at least six test sheets of stock.
Check each sheet for:
High Topping
●
Roller tension.
●
Steel ball placement.
Cut (tab and edge of stock)
●
Knife blade adjustment
●
Dull knives
BAD FILM
SEAL
Fig. 3-71. Film Seal
Film Seal (adhesiveness to stock)
●
Heat or seal time
●
Bad film
●
Bad paper stock
Make necessary adjustments and repeat until
problem is corrected.
Note !
The film may not adhere to some
coated stocks. Aqueous and
Varnished stocks tend to release gas
when laminated and cause bubbles in
the film. Also, coated stocks tend to
isolate the film from the paper thus
not allowing the plastic to adhere to
the paper fibers.