Scott 10,000, Instruction Manual

Page: 127 / 323

4 Maintenance
4--20
C9999--2 Issue 1
GEARBOX
CONNECTING
BLOCK
REREGISTER SLIDE
OPERATING ARM
GEARBOX SHAFT
CLAMP SCREW
Fig. 4-24. Locate the Reregister Section (View
from Under Machine)
4.2.9 Reregister Section
Reregister section is located after the heat rollers
underneath the cross conveyor before the tab
cutter end of the machine. The reregister arm is
attached to the gearbox output shaft. The gearbox
drives the reregister slide operating arm or “jogger”
back and forth.
CLAMP SCREW
(SOCKET HEAD)
7 O’CLOCK
6 O’CLOCK
15
_
CONNECTING
BLOCK
Fig. 4-25. Position of Reregister Slide Operating
Arm
Step: 1. The socket head clamp screw located on
the block should be aligned to the 7
o’clock position when viewed from the
tab cutter end of the machine.
Step: 2. To reposition clamp screw, loosen screw
and rotate block until the screw is in the
correct position.
Step: 3. Retighten screw.