Scientific SMO1002, User Manual

Page: 80 / 102

80
d) Self Calibration
Self Calibration procedure can optimize the signal path at the most measurement precision. You can run
this procedure at any time. If the operating temperature changes by more than 5° C or the units run more
than thirty minutes, you should do the self calibration.
When you run the self Calibration, you should cut off all the probes and lead. Then press the “Utility” button
to choose the “Do self cal” to show the self Calibration Menu, and execute self calibration program
according to the prompting on the screen.
e) Self Test
Press “UTILITY” → “Do Self Test”
Operation Steps:
1. Screen Test:
Select “Screen Test” to enter the screen test interface. The clew words “Press ‘SINGLE’ Key to
continue, Press ‘RUN/STOP’ Key to exit” is displayed, you could press the “Single” for test.
Fig. 66 Screen after Self Calibration Execution
Table 56: Self Test
Fig. 66 Screen after Self Test Execution
User Manual SMO702, SMO1002