Schwing SP 1800-D, Original Operating Instructions

Page: 39 / 390

1.7-3
005.142.08-EN
1.7.4 IOPU TIER 4 CONTROL PANEL
(Fig. 7); (Fig. 8)
1. Yellow "fault/warning indicator" light
indicates errors reported via the CAN bus.
2. Red "fault/warning indicator" light
indicates a shutdown reported via the
CAN bus.
3. "Regeneration request" button: The
operator can use this button to send a
regeneration request to the motor for the
purpose of carrying out an active
regeneration, see chapter 1.7-5.
INFORMATION
Note that regeneration occurs automatically
with the SP 1800 CAT TIER 4i and 2800
TIER 4f.
4. "Regeneration suppression" button: The
operator can use this button to send a
signal to the motor to instruct it to
suppress an active regeneration, see
chapter 1.7-5.
5. "Enter" button: The operator can use this
button to select settings in the settings
screen for adjustments and saving.
6. "Right arrow" button: The operator can
use this button to scroll through error lists
in measurement display screens and
through settings in the settings screen.
7. IOPU control station connector: Connects
the IOPU control station to the motor
wiring harness.
8. "Left arrow" button: The operator can use
this button to scroll through error lists in
measurement display screens and
through settings in the settings screen.
9. "Back" button: The operator can use this
button to move between various screens
and to quit the displayed settings without
saving.
Fig. 7; IOPU Tier 4i, Stage IIIB, control panel
Fig. 8; IOPU Tier 4f, Stage IV, control panel
10. The “Speed reduction” button : The
operator can use this button to reduce the
speed of the motor via the CAN bus by
using TSC1. Pressing the button displays
the desired motor speed screen to the
operator. ("Reduction step" = 25 rpm,
adjustable standard value; return time
"Hold" = 200 rpm, adjustable standard
value)
11. The “Speed increase” button : The
operator can use this button to increase
the speed of the motor via the CAN bus
by using TSC1. Pressing the button
displays the desired motor speed screen
to the operator. ("Increase step" = 25
rpm, adjustable standard value; ramp-up