Schwing SP 1800-D, Original Operating Instructions

Page: 295 / 390

4.40-3
001.193.16-EN
Metallic contact between rock 5 and housing
lining 6 (Fig.: 7 - Fig.: 8) indicates an error. For
example:
- Kidney seal 7 defective
- Adjusting nut 1 too tight
- Cutting ring jammed
- During assembly, too much grease used or
parts not carefully cleaned.
SET AXIAL PLAY OF THE SLEWING SHAFT
- Remove safety screw 3 (Fig.: 7) with disc.
- Set distance "B" = 1.5 to 3 mm with the
adjusting nut 1.
- Align bore in the collar of the adjusting nut
with the nearest threaded bore of the locking
disc 2 (advance and turn back the nut).
- Mount safety screw 3 with disc.
CHECK CUTTING RING
The cutting ring and wearing insert of the
housing lining are worn unevenly by external
influences (e.g. several types of concrete) and
different stresses in sub-areas (area "C",
Fig.: 9).
Fig.: 7
Fig.: 8
Fig.: 9