Schwing SP 1800-D, Original Operating Instructions

Page: 41 / 390

1.7-5
005.142.08-EN
1.7.5 "Regeneration" work instruction
INFORMATION
Engine power failure!
Observe the possible automatic
regenerations of the diesel engine.
The motor speed can be lowered
automatically or the diesel engine will be
switched off in pumping operation.
Carry out the regeneration in due time
according to the motor manufacturer
regulations.
ATTENTION
Machine parts or the entire machine can be
destroyed.
Follow the following description carefully for
the manual “regeneration”.
Implementation of regeneration for Caterpillar
motor CAT C7.1 Acert Tier 4i.
1. The degree of clogging is displayed on the
Caterpillar display, item 0 (Fig.; 10)
(Bar diagram or percentage)
(Example, 50% clogging in this case)
2. Automatic regeneration of the diesel particle
filter (DPF) can already be carried out from a
degree of clogging of 30%.
3. Automatic regeneration of the diesel particle
filter (DPF) is required from a degree of
clogging of 80%; a control light appears on
the display.
4. At a degree of clogging of 100%, the
following lights up on the display:
and .
5. Further use without regeneration will result in
the motor performance being independently
reduced.
6. If the degree of clogging increases further,
then a warning buzzer sounds in addition to
the indicators.
7. After the warning buzzer has been sounding
for 5 minutes, the motor switches to idling
speed.
8. Within the next 10 minutes of idling,
regeneration must be carried out.
9. If generation is not carried out, then the
motor is automatically locked and shuts
down. On restarting, the motor shuts down
again after 30 seconds and can only be
unlocked again by authorised service
technicians.
10. If, despite these locks, the motor continues
to be run, then this can lead to the DPF
being replaced.
Fig.; 10; control panel