Schwing SP 1800-D, Original Operating Instructions

Page: 290 / 390

4.30-2
004.491.01-EN
CLEAN FILTER ELEMENT
Renew element after 3 cleanings or no later
than after one year.
ATTENTION
Never wash or brush filter element or clean
by slamming.
Cleaning is done with clean and dry
compressed air (max. 5 bar). Dust may not get
to the inside of the element when blowing out
dust.
- A tube, whose end is bent by approx. 90°,
should be placed onto the compressed air
gun. It must extend to the bottom of the
element (fig. 1).
- Blow out element from the inside out by up
and down movements until dust no longer
escapes (fig. 2).
Do not damage element.
CAUTION
Health hazard!
Do not inhale dust! Wear respiratory
protection (dust mask)!
- Inspect the cleaned element for damages
(paper bellows, seals) before re-installation.
Cracks and holes in the paper bellows can be
detected with a flashlight (eg. 3).
ATTENTION
Motor damage!
Do not continue to use damaged element.
Replace with original spare part, if in doubt
Fig. 1
Fig. 2
Fig. 3