Schwing SP 1800-D, Original Operating Instructions

Page: 145 / 390

3.20-1
004.551.01-EN
INSTALLING THE MACHINE
OBSERVE
SAFETY MANUAL
The installation site must be set up so that the
transport vehicles can reach the concrete filling
hopper without problem and the machine is
accessible for maintenance and cleaning.
- Inquire about the permissible ground pressure
at the construction site. The maximum ground
pressure of the ready-to-operate machine,
including 500 l of concrete without underlay
support, per supporting stand is:
front
approx.
3
daN
cm
2
(
3
kg
cm
2
)
rear
approx.
6
daN
cm
2
(
6
kg
cm
2
)
Deviations are possible due to different
equipment versions.
- If necessary, use load-distributing underlay
supports beneath the supporting dish.
DANGER
Loss of stability!
The machine must not be installed when its
maximum ground pressure exceeds the
permissible value.
If necessary, the support surface must be
extended using suitable means until the
permissible ground pressure is reached.
Depending on the dwelling time of the machine,
we recommend the use of our spacers (item
no.: 1095646) or the implementation of a
suitable concrete surface.
ATTENTION
Extend hydraulic supporting stands evenly.
Do not drive a cylinder to the limit stop before
the next one has been driven. The frame and
outrigger were put under unnecessary strain.
If load-distributing underlay supports are
used, they must be suitable and undamaged,
as well as free of ice, oil, grease etc.
STOPPAGE TIMES
- Secure the machine against unintentional
changes of position, even during short
stoppage times.
INFORMATION
Brake wedges are not included in the scope
of delivery of your machine. Machines
without a chassis frame for road traffic have
no brakes.
If the machine remains for a longer time at an
installation site, we recommend that the wheels
are removed (prior to lifting, loosen the wheel
nuts).
Store the wheels and cover the wheel hubs.