Schwing SP 1800-D, Original Operating Instructions

Page: 354 / 390

4. OPERATING THE UNIT Safety equipment in the NBB-radio remote control:
In the transmitter
In the receiver:
If the NBB radio remote control is not used for a long period, it is urgently recom-
mended - if you use rechargeable batteries - that they should be charged now
and again (about every 4 weeks). This prevents deep discharges of the batteries
and prolongs their useful life. If you shut down the NBB radio remote control for a
long period, we recommend you take the batteries out of the transmitter.
Frequency change Planar-V4:
, this comprises mainly:
STOP (transmitter ON/OFF) with automatic disconnection of the power supply.
Automatic zero positioning.
Automatic zero setting when switching back on after radio interruption.
Locking of the radio commands at relay level in the event of a defective STOP circuit.
To ensure fault-free operation, please follow precisely the following rules for operation:
The unit to be controlled can only be switched on - it is assumed that the transmitter is
ready to operate - when no command unit is actuated. The command necessary to do so
is triggered by the key "ON/HORN". This triggers a horn signal in the unit to be controlled.
After switch-on of the facility to be controlled, this key is used for repeated emission of the
horn signal in accordance with working regulations.
A manual frequency change isn’t necessary. By turning on the receiver locks into the new
frequency, which will be shown shortly in the 7- secment functional display. If it’s neces-
sary to change the channel, the transmitter has to be turned off and on again.
The selection of the channel happens automatically.
%
%
%
%
Display of the channel: e.g. channel 53
Channel, which has been
chosen automatically.
Turn on / Turn off
Turn on: The toggle switch ON/OFF turn to ON, until the red dot flashes.
Turn off: The toggle switch ON/OFF turn shortly to OFF until the red dot dosn’t flashes
anymore.