Instructions for use arco-matic 200 M / 300 M - Version 2018-05-08 GBR ID no. 2038823A
47
Mounting the Göpel leg support
Loosen the toggle screw of the attachment clamp.
Turn the mounting hole to the desired angle.
Insert the rod into the mounting hole of the
attachment clamp. The bottom end of the rod
must protrude from the attachment clamp.
Tighten the toggle screw of the attachment
clamp. The gear teeth must interlock again.
WARNING!
If the rods are not fully inserted or the toggle screw
has come undone, the Göpel leg support can move
unexpectedly causing hazardous situations!
The mounted rod must be inserted fully into the bar
mount (the bottom side must be level with the lower
opening or protrude from the opening)!
Tighten the lower toggle screw each time you adjust
the Göpel leg support!
Adjusting the Göpel leg support
Loosen the toggle screw of the attachment clamp.
Change the inclination of the rod as required.
Turn the rod around its own axle as required. The
cradle will turn inwards or outwards as shown in
Fig. 61.
WARNING!
Risk of injury!
Turning the lever beyond an angle of 45° (as shown
in Fig. 61) can cause the side rail to unexpectedly
give way under load. This sudden movement could
cause personal injury when being used by the
patient.
Therefore, do not use the Göpel leg support when it
is rotated more than 45° away from the examination
and treatment chair!
Tighten the toggle screw of the attachment
clamp. The gear teeth must interlock again.
Fig. 60
Inserting the rod
1) Toggle screw of the attachment clamp
Fig. 61
Do not swivel the Göpel leg support outwards more
than 45° during use!