Instructions for use arco-matic 200 M / 300 M - Version 2018-05-08 GBR ID no. 2038823A
15
Transport at destination
To lift the examination and treatment chair, e.g. from
a pallet, the cladding must fi rst be removed from
both foot sections. The chair must be lifted with
carry straps (included in the delivery).
The following steps must be followed even if, at a
later stage (e.g. after fi nal use), the examination and
treatment chair is to be moved and the chair is not
equipped with a mobility function.
Attaching the carry straps
The examination and treatment chair comes with
foot supports, which are fi tted as shown in Fig. 6.
The foot supports are fi tted the other way round
for delivery: the right foot support is on the left side
and vice versa. The foot supports must be removed
before the examination and treatment chair is trans-
ported at the destination.
Remove the attached foot supports.
Keep the right and left foot supports separately.
Each is to be fi tted on the other side respectively
once the examination and treatment chair has
been set up (see “Setup” on page 16).
Fig. 6
Foot support, before assembly
1) Foot support
Attach two carry straps each on the left and right
side as shown in Fig. 7 or in Fig. 8.
Lower the examination and treatment chair from
the pallet. This must be done by four people.
NOTE
The examination and treatment chair will be
damaged if it is lifted by the back pad and seat pad.
The examination and treatment chair must therefore
always be lifted by the foot section.
Moving at the destination
Models with a mobility function can also be trans-
ported at the destination by moving the examination
and treatment chair along to the desired location.
Please refer to the instructions in chapter “Mobility
(101.0466.0)” on page 54.
Fig. 7
Attaching carry straps (for non-mobile models)
1) Carry strap
Fig. 8
Attaching carry straps (for mobile models)