3 Assembly and startup
SCHMIDT
®
PressControl 3000 – V1.3
11
3 Assembly and startup
Safety instructions
The control unit may only be installed and serviced by setup engineers
who have been commissioned and trained by the company.
Any work on the electrical equipment of the press must be carried out
only by trained electricians or by specially instructed persons under the
control and supervision of a trained electrician and in accordance with
the applicable electrical engineering rules and regulations.
Check the control unit, accessories and all supply lines for possible
damage prior to each startup.
Switch off a defective press immediately or depressurise the pneumatic
system immediately and have the malfunctions repaired as soon as
possible.
3.1 Transport and storage
Check the delivered press system components for visible transport
damage.
Report any transport damage immediately to the following authorities:
- the forwarding agent
- the dispatch department of SCHMIDT Technology.
Keep the original packaging for later transport and/or for further storage.
Use the original packaging for further transport (service, repairs….).
Ensure proper packaging of the components.
Ensure proper packaging of the components, if they must remain
unused for longer periods.
Store the control unit in upright position (do not place on the display)
Store the control unit in such a way that it is not subject to large
fluctuations in temperature. Otherwise, the resulting condensed
moisture may cause corrosion on critical press or control unit
components.
Please observe the information on the ambient conditions in chapter
"2.2 Technical Data".
CAUTION
!
Delivery
Transport
Storage
