Error messages
162
Operating Manual XCx 300 / 500 / 540 Version 09/08
0x02300067
MC: fehlende/fehlerhafte Parameter in
Datei (drive_*.ini)
(File_ID=m)
[MC: Missing or defective parameter
in file (drive_*.ini)
(File_ID=m)]
No current value was found in the INI file or
the parameter does not exist.
0x02300068
MC: Datei (drive_*.ini) ist fehlerhaft
(File_ID=m)
[MC: File (drive_*.ini) is defective
(File_ID=m)]
The INI file contains invalid or defective data.
0x02300069
Warnung: MC: neue Achse (mit
Default-Einstellungen) eingefügt
(File_ID=m)
[Warning: MC: New axis inserted (with
default settings
(File_ID=m)]
Note, warning:
One or more axes have been inserted in the
XCN.
0x0230006A
Warnung: MC: nicht zugeordnete
Achse(n) in Datei (drive_*.ini)
(File_ID=m)
[Warning: MC: File (drive_*.ini)
contains non-assigned axis/axes
(File_ID=m)]
Note, warning:
One or more axes have been deleted in the
XCN.
0x0230006B
Warnung: MC: Zuordnung der Achsen
wurde geändert in Datei (drive_*.ini)
(File_ID=m)
[Warning: MC: Axis assignment
changed in file (drive_*.ini)
(File_ID=m)]
Note, warning:
The assignment of one or more axes has
been changed in the XCN.
0x0230006C
MC: Datei (drive_*.old) kann nicht
generiert werden
(File_ID=m)
[MC: File (drive_*.old) cannot be
generated
(File_ID=m)]
The OLD file could not be generated.
0x0230006D
MC: Datei (drive_*.crc) kann nicht
generiert werden
(File_ID=m)
[MC: File (drive_*.crc) cannot be
generated
(File_ID=m)]
The CRC file could not be generated.
0x0230006E
MC: temporäre Datei (drive_*.ini) ist
nicht vorhanden
(File_ID=m)
[MC: Temporary file (drive_*.ini) does
not exist
(File_ID=m)]
The drive_*.ini file on the RAM disk in the
XCN
– with the drive parameters that have
been edited online
– does not exist after the
accept request.
0x02300095
MC: TaskSynchronisation TIMEOUT
The time limit for initial MotionControl task
synchronization with the interpolation task
has been exceeded.
Check the interpolation cycle time and the
MotionControl cycle time.
Dividing the interpolation cycle time by the
MotionControl cycle time must produce a
whole number.
(Interpolation cycle time / MotionControl cycle
time) = whole number
