Schindler 3100/3300/6300
J 43402603 / 01
62/269
Copyright © 2017 INVENTIO AG
Step 1
Accessing the Car Roof
Preparation for entering car roof:
–
Activate the "Automatic Car Positioning Sequence" by pressing the "RESET
INSPECTION" button on SMICHMI for more than 3 seconds when controller is in
normal mode
–
All registered car calls are served and all landing calls are cancelled
The car first travels to the landing floor where the controller is installed and opens
the doors, allowing the maintenance person to check that the car is empty
–
Press "RESET INSPECTION" button again
–
The doors are closed and the car starts to travel down until the car roof is at the floor
level of the landing where the controller is located
–
Open the landing door with a triangular key. This activates the TSD21 safety system.
–
The elevator status indication on the HMI changes to "67"
–
Press JHC
–
Enter the car roof.
When the procedure is stopped in step 4, the elevator
will go back to Normal Mode
after 180 seconds.
Step 2
Entering the car roof and activating the Inspection Mode
Once the fitter has accessed the car roof, he can activate the Inspection Mode by after
turning the TSD21 lever.
Activation:
–
Activate the TSD21 lever
–
If necessary, extract/unfold the balustrade
–
Switch JREC to "Inspection"
–
Release JHC only if JREC has been switched to "Inspection"
The elevator status indication on the HMI changes to "54", which means that the top
of car inspection mode is active.
WARNING
DRZS reset button
To avoid unauthorized resetting of the monitoring system
Before starting the procedure, the DRZS reset button must to be locked or secured
with a padlock to avoid unauthorized resetting of the monitoring system when the pit or
roof are accessed.
