Two-way wireless system ABAX
ACU-100
4
CON
- information output - no radio communication with wireless device
JAM
- information output - radio jamming
LBA
- information output - problems with wireless device power supply
OUT1…OUT8
- information output - wireless equipment status
AR1…AR4
-
control
inputs
A RS485 B
- RS-485 port terminals (not used)
CLK
,
DAT
-
communication
bus
The tamper contact
reacts to of the controller housing being opened. You can use the TMP
terminals in two ways:
•
connect the terminals to the tamper circuit of the control panel;
•
connect one of the TMP terminals to the ITMP tamper circuit input, and the other to the
COM ground terminal – information of the controller tamper will be fed to the TPR output
and to the communication bus.
Note:
If the TMP terminals are not connected to the controller tamper circuit, the ITMP
terminal must be shorted to the common ground.
The package of DIP-switches
on the board is used to set individual addresses of the
devices and to configure some working parameters of the controller (see F
UNCTIONS OF
DIP-
SWITCHES
).
The LED
indicates the controller status. The mode of lighting depends on the controller
working configuration:
•
interaction with CA-64 or INTEGRA alarm control panels:
−
green steady light – no communication with the control panel;
−
green blinking light – correct communication with the control panel.
•
interaction with other alarm control panels:
−
green steady light – normal operation of the controller;
−
green blinking light – synchronization in the process;
−
alternate green and red blinking light – occurrence of one of the problems signaled on
functional outputs (see: F
UNCTIONAL OUTPUTS
).
The buzzer
informs of occurrence of one of the problems signaled on functional outputs (it
does not apply to the controller interfacing with the INTEGRA series alarm control panels).
The RS-232 port with optoisolation
enables a PC computer with D
LOAD
10
program to be
connected for the time of programming.
The RJ-11
socket
is used to connect an LCD keypad for the time of programming. The
controller interfaces with LCD keypads for operating the CA-64 or INTEGRA series control
panels.
Notes:
•
The controller cannot be simultaneously programmed by means of computer and LCD
keypad.
•
When working with the INTEGRA alarm control panels, the controller can be programmed
by means of the control panel, with no need for connecting the keypad or computer to the
controller sockets.
The communication bus (CLK, DAT)
of the controller enables direct connection to the
control panel communication bus (INTEGRA, CA-64, CA-10) or expansion of the system by
adding the ACX-100 input/output expansion modules.
