Two-way wireless system ABAX
ACU-100
14
−
turn on the ARF-100 tester – immediately after start-up, the tester will send a single
signal to enable registration,
−
plug the ASW-100 E / ASW-100 F wireless controller into the 230V socket –
immediately after being plugged into the socket, the controller will send a single signal
to enable registration,
−
violate (open) the tamper contact in case of the other devices.
If an invalid serial number has been entered, you will be informed of it by a suitable
message. Then you should enter the correct serial number and repeat the above
mentioned step.
4. A confirmation message will be displayed that a new device has been added. Click your
mouse on the „OK” button to finish the procedure of new device addition. You can cancel
addition of the new device by pressing the „Abort” button. You can also add a next
wireless device by pressing the „Next” button.
Note:
If the ACU-100 controller is configured for operation as the expander with the CA-64 or
INTEGRA control panels, the procedure of adding new wireless devices to the system
must be followed by the procedure of expander identification in the control panel.
4.5.2 LCD keypad connected to the controller
In order to add a new wireless device to the system, do the following:
1. Start the N
EW DEVICE
function.
2. Enter the 7-digit serial number of the device to be added and press the [#] key. The serial
number can be found on the electronics board or on the housing. Each radio signal level
tester has the serial number 0000500.
3. Depending on which device is to be added to the system:
−
turn on power supply of the ACX-200 expander – immediately after start-up (power-up),
the expander will send a single signal to enable registration,
−
turn on the ARF-100 tester – immediately after start-up, the tester will send a single
signal to enable registration,
−
plug the ASW-100 E / ASW-100 F wireless controller into the 230V socket –
immediately after being plugged into the socket, the controller will send a single signal
to enable registration,
−
violate (open) the tamper contact in case of the other devices.
If the entered serial number is different from that of the device being added, or a device
with this number has already been registered, a message with suitable information will be
displayed, followed by the automatic return to the main menu.
4. A message will confirm addition of the new device with the serial number shown on the
display. Press the [#] key to finish the procedure of adding the new device. You can
cancel the new device addition by pressing the [*] key.
4.5.3 LCD keypad of INTEGRA alarm system
In order to add a new wireless device to the system, do the following:
1. Start the function N
EW DEVICE
(
Æ
S
ERVICE MODE
Æ
S
TRUCTURE
Æ
H
ARDWARE
Æ
E
XPANDERS
Æ
S
ETTINGS
Æ
controller name
Æ
N
EW DEVICE
)
2. Enter the 7-digit serial number of the device and press the [#] key. The serial number can
be found on the electronics board or on the housing. Each radio signal level tester has the
serial number 0000500.
If a device with the entered serial number is already registered in the system, the keypad
will signal it by 3 long beeps and will fail to proceed to the next step of the procedure.
