ACU-100 SATEL
35
The menu of service mode in LCD keypad connected to the controller:
Service end
New device
Remove device
Device names
Serial number
Inputs
Outputs
Settings Response
period
Filter
Configuration
Trouble
indication
Input
types
Output
type
Set
defaults
Tests Signal
level
Communications
state
Tamper
state
Battery
state
Jamming
Test
mode
Clear
memory
Synchronization
Supply
voltage
Service code
Overview of all functions - see Section D
ESCRIPTION OF FUNCTIONS
,
OPTIONS AND COMMANDS
.
6.4
D
LOAD
10
PROGRAM
In order to configure the ACU-100 controller or carry out diagnostics of the wireless devices
by means of the D
LOAD
10
program, do as follows:
1. Set the option of programming through the RS-232 port on the DIP-switches on the
controller electronics board (this is not required when the controller operates in
configuration of expander of wireless devices for the INTEGRA control panels).
2. Connect computer to the controller (see:
CONNECTING COMPUTER TO THE CONTROLLER
).
3. Launch the D
LOAD
10
program in the computer (access to the program is protected with
password, which is
1234
by default and can be changed to any sequence of 16
characters – digits from 0 to 9 and letters from A to F).
4. Open the "Communication" menu, select the "Configuration" item and indicate the
computer port to which the controller is connected.
5. Open the "File" menu, select "New device", and then "ACU-100".
