Sartorius Combics CAH1, Operating Instructions Manual

Page: 71 / 168

Operating Instructions Combics Indicators 71
CTRL.SET
Activate SET control output 4.3.
OUTPUT
SET output 4.3.1*
OP.READY
Ready to operate 4.3.2
OUTP.ACT
Activation of outputs 4.4.
OFF
Off 4.4.1
ALWAY.ON
Always on 4.4.2
STABIL.
At stability 4.4.3
CHECK.RG
Within checkweighing range 4.4.4*
STAB.CHK
On at stability within
checkweighing range
4.4.5
INPUT
Parameter input 4.5.
TAR.MN.MX
Min, Max, target value 4.5.1*
TARG.PER
Only target value with percent limits 4.5.2
TAR.A.PER
Target value with asymmetrical
percent limits
4.5.3
TAR.TOL
Target value with relative tolerances 4.5.4
AUT.PRNT
Automatic printing 4.6.
OFF
Off 4.6.1*
ON
On 4.6.2
OK
Only values within tolerance 4.6.3
NOT OK
Only values outside tolerance 4.6.4
APP.ZERO
Checkweighing toward zero 4.7.
OFF
Off 4.7.1*
ON
On 4.7.2
)
� t
To save the setting, press the
)
key.
( (
...
t
To exit setup: Press the
(
key several times.
Display
The result of a measurement is shown either as a weight value or in relation to the
target.
Weight display:
The measured value line always shows the weight value, even if it
lies outside the tolerance range. The bar graph is displayed with symbols indicating
lower limit, target and upper limit. Weights are shown logarithmically up to the
lower tolerance limit, and linearly beyond that point.
Relation to target value
: As “Weight display” above, with the exception that:
–
LL
appears in the main display if the weight value is less than the lower limit
–
HH
is shown on the main display if the weight value is higher than the upper
limit
Digital Input/Output Interface
The
Checkweighing
application supports the digital input/output-interface.
The four outputs are activated as follows:
– Lighter > red LED lights
– Equal > green LED lights
– Heavier > yellow LED lights
– Set
The outputs can also be galvanically isolated using option A5.
Acoustic signal: An acoustic signal can be activated in addition to the green LED.
Setting: menu item 8.2.3
Operation