Sanyo SPW-CR365GX56, Technical Data Manual

Page: 74 / 345

3
3 - 28
Control of Mini ECO-i SYSTEM
3. Wired Remote Controller
J: TIMER SET button
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
Use this button while the unit is operating to switch between timer settings.
: The air conditioner stops after a preset time elapses.
: The air conditioner always stops after a preset time elapses.
: The air conditioner starts after a preset time elapses.
K: Time setting buttons : Press this button to increase the time.
: Press this butt
tton to decrease the time.
L: SET button Use this button to set the timer.
M: CL button Use this button to clear the timer setting.
N: VENTILATION button This is used when a ventilation fan (available commercially) is connected.
Pressing the VENTILATION button turns the fan on and off. The ventilation
fan also turns on and off when the air conditioner unit is turned on and off.
(The display of the remote control unit shows “
” while the ventilation fan
is running.)
*
If “ ” is shown on the display of the remote control unit when the
VENTILATION button is pressed, this indicates that the ventilation fan is
not connected.
O: Remote control sensor Normally, the temperature sensor of the indoor unit is used to detect the
temperature. However, it is also possible to detect the temperature around
the remote control unit.
For details, contact the dealer where you made the purchase.
(Do not set when using group control.)
1) When 2 remote control units are being used in one group control*
system,
a) the most recent button that is pressed on any remote control unit is
effective.
b) either a main-remote control unit or a sub-remote control can set the
timer.
* Group control means that maximum up to 8 indoor units can be
concurrently controlled with a remote control unit.
2) If a power failure occurs in timer mode, the time counted up to that point
will be stored in memory.
After power is restored, the timer starts again counting up to the set time.
NOTE
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 28