Sanyo SPW-CR365GX56, Technical Data Manual

Page: 112 / 345

3
3 - 66
Control of Mini ECO-i SYSTEM
5. Schedule Timer
STEP 3 Set up the program and press the SET button.
• Select timer operation with the (timer ON/
OFF) button and (remote controller operation
enable/disable) button. Then, set the trigger time with
the HH and MM buttons, and press the SET button.
•
•
•
•
•
•
•
•
•
•
•
When the SET button is pressed, the time set in
program
changes from blinking to lighting and, at
the same time, the time set in program starts
blinking.
NOTE
Every time the button is pressed, the timer
indication changes in the order of (ON)
(OFF) no indication.
Every time the button is pressed, the remote
controller indication changes in the order of
(enabled) (disabled) no indication.
The remote control operation enable/disable setting is
disabled depending on installation conditions. In this
case, only timer ON/OFF can be set.
STEP 4 Set up programs ~ in the same way.
When the SET button is pressed, settings are
automatically arranged in the order of earliest time
first.
If the SET button is pressed without any new settings
being made in the program, program
starts
blinking again and settings can be changed.
Similarly, if the SET button is pressed after setting up
program , program starts blinking again.
STEP 5 Press the PROGRAM button.
Program settings are entered and the normal display
returns.
STEP 6 Set up programmed operation for other groups and days of the week in the same way.
Programs that have already been set up can be copied into other groups and days of the week. (Refer
to pa
NOTE
A “0:00” time setting is interpreted to mean 12:00 midnight.
To cancel program settings during program setup (while “PG-1” or “PG-2” is blinking on the
display), hold down the CANCEL button for more than 2 seconds. The normal display
returns.
If settings are canceled without pressing the PROGRAM button, settings are not entered.
ge 3-68.)
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 66