Sanyo SPW-C0705DZH8, Technical Data Manual

Page: 115 / 703

(b)
(c)
1 2 3 4 5 6
2-3
1.
2.
1 1
How to Perform Zone Registration
To operate the system controller properly, zone registration is required after
finishing the test run (and after setting all indoor unit addresses) using one of
the following methods.
Zone registration using the remote controller (RCS-TM80BG)
Refer to page 3-65
Zone registration using the system controller (SHA-KC64AGB)
Refer to page 3-66
Automatic zone registration using the system controller (SHA-KC64AGB)
Refer to page 3-66
For methods (a) and (b), you should make a zone registration table manually
before performing the registration. Use the form on page 3-66 for this.
For method (c), zone registration is executed automatically, proceeding from
small indoor unit addresses and small central addresses to larger numbers in
numerical order. For example:
Central address
ZONE-group
Indoor unit address 1-1
1-1 1-2
1-2
1-3
2-1
1-4
2-2
1-5 1-6
3-1
An indoor unit address is assigned to each indoor unit during automatic
address operation. Each indoor unit address combines an R.C. address
and indoor unit number as follows:
: Indoor unit address (UNIT No.)
Indoor unit No.
Refrigerant circuit No. (R.C. address)
This address is displayed on remote controller for UNIT No. when the UNIT
button is pressed.
The central address represents the zone and group number. These
addresses are assigned in ascending numerical order.
(a)
NOTE
3-63
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. System Controller
TD831143-00̲W-3WAY.indb 63 TD831143-00̲W-3WAY.indb 63 2008/12/01 10:26:41 2008/12/01 10:26:41