UPS Installation and Wiring
24
§
§
6
6
.
.
4
4
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
n
n
g
g
O
O
p
p
t
t
i
i
o
o
n
n
a
a
l
l
D
D
e
e
v
v
i
i
c
c
e
e
s
s
Connect to the external interface if you are using communication cables or optional devices. For details on the functions
of the external interface area, see “§5.4 External Interface.”
Connect optional devices before starting the UPS. If you want to connect optional devices after starting the UPS,
completely stop the UPS, turn OFF the power supply, and then connect the devices.
For details on wiring and settings, see the instruction manuals of the optional devices. For details on optional devices,
contact your sales representative or SANYO DENKI.
Connecting REMOTE/EPO terminals
Connect and use, for example, a switch or a contact of the customer’s system that
matches the terminal specifications.
For details on terminal functions, see “§5.4 External Interface,” Section
⑤
.
Connect a SANYO DENKI LAN
interface card (option).
For details, see the instruction
manual of the LAN interface card.
Connecting to the terminal
Connect when using the external
transmission signal functions.
For details on connector functions, see Ҥ5.4
External Interface,” Section
③
.
This completes installation and wiring of the UPS.
Back of UPS Unit 1
Connect the dedicated communication cable to use the SANYO DENKI
power management software.
With UPS and computer communication, you can manage the power
supply from a computer. For details, see the instruction manual of the
power management software.
Main screen of the power management software SANUPS SOFTWARE
9～
10
mm
導
通
部
Insert and remove the wire
while pressing the tab with a
flat-head screwdriver or
similar tool.
Good connection cannot
be made if the conductive
part is too short.
Compatible wires: AWG26 to 20
①
Peel off the outer coating at the end of
the wire by approximately 9 to 10 mm.
②
Insert the wire into the terminal while
pressing the tab with a flat-head
screwdriver.
③
Pull the inserted wire to make sure
that it does not come out.
