UPS Installation and Wiring
20
⑤
Remove the battery securing bracket.
⑥
Insert two battery packs into the unit.
⑦
Attach the battery pack securing bracket that
you removed in step
⑤
.
⑧
Insert one end of the LCD panel connection cable into
the connector at the position shown in the figure.
Back of Front Panel
⑨
Insert the other end of the cable connected in step
⑧
into the connector on the back of the front panel.
⑩
Check that the forced bypass switch
Forced Bypass
located above the connector is set to the “
Inverter
” side.
Check the two UPS Units.
⑪
Secure the front panel using the two screws on the left and right.
⑥
With the connector
parts facing toward the
back, insert the battery
packs starting with the
one on the left.
⑩
Is the switch set to
the “
Inverter
” side?
⑨
Check
the
insertion
orientation of the connector.
You cannot insert the
connector if the connector
orientation is wrong.
⑪
Tighten the screws on the
right and left using a
screwdriver or the like, and
secure the front panel.
⑧
Insert one end of the
connection cable into
the connector.
⑤
Remove the screw on the
right side first, and then
take out the tab on the left
side from the cutout hole,
and remove the battery
securing bracket.
CAUTION
！
The weight of one battery pack is 17.5 kg.
Take care not to drop them. Insert the
battery pack on the left side first when
installing the UPS horizontally, and at the
bottom first when installing the UPS
vertically.
1
2
The battery pack securing bracket cannot be attached if
the battery packs are not inserted properly.
Be sure to insert the battery packs fully inward.
Note on attaching battery pack securing bracket
⑦
Insert the tab on the
left side first, and
then secure the right
side with the screw.
The battery packs A and B can be inserted
on either the left or right side of UPS Unit 1
and UPS Unit 2.
Proceed to step
⑩
.
UPS Unit 1
UPS Unit 2
Proceed to step
⑧
.
UPS Unit 1
UPS Unit 2
