S&C Instruction Sheet 681-530
15
Reinstalling the Electronics Module
STEP 3.
Tighten the four captive screws that secure the electronics module to the base
plate. Start tightening the screws by hand to avoid cross threading. See
Figure 8.
STEP 4.
Connect the two trip connectors to the front of the electronics module. The trip
connectors are keyed and cannot be swapped or installed incorrectly. Connect
the USB connector to the USB port on the electronics module. See Figure 9.
Figure 8. Lower the electronics module onto the base plate and tighten the four captive screws.
Figure 9. Reconnect the trip connectors and the USB connector to the electronics module and
screw them in securely.
Screws
(not
visible)
Screws
USB
connector
Trip
connectors
