S&C Instruction Sheet 681-530
11
NOTICE
Always disconnect the trip connectors from the electronics module before removing
the module from its base plate . Failure to follow this precaution may result in the
unexpected operation of a fault interrupter .
Removing the Electronics Module for Service Center Programming
NOTICE
S&C does not recommend removing the submersible S&C Overcurrent Control
used in UnderCover Style and Wet-Vault Mounted Style Vista switchgear from its
enclosure for workbench programming . Opening the submersible enclosure may
damage the sealing gasket . Contact your local S&C Sales Office or the S&C Global
Support and Monitoring Center at 1-888-762-1100 (or 1-773-338-1000 outside the
U .S .) for more information .
The control can be removed from a non-submersible enclosure for programming. To
remove the module:
STEP 1.
Loosen the captive screws that secure the cover of the control enclosure and
remove the cover. See Figure 2.
Screws
Screws
Figure 2. Remove the overcurrent control enclosure cover.
