Samyung ENC SMR-715 series, Instruction Manual

Page: 80 / 192

54
Chapter 5 VARIOUS FUNCTION ICONS
5.3 CURSOR FUNCTION
Adjust the cursor position
The cursor elimination method
Using the cursor function can read out a selected target information.
Tap the cursor icon. Tap anywhere on the screen, the cursor mark is
displayed in place where it has been tapped. At the same time, the range and
bearing information at that point are displayed in the lower side of the screen.
If the GPS signal is coming in, the latitude and longitude information of that
point are also can be displayed.
Tap anywhere on the screen
“BEARING”
BRG 20.0°
“RANGE”
RNG 0.3464NM
“TTG”
TTG +2.1MIN
In case of GPS signal coming in
“Latitude “ LAT 35° 04.2292’N
“Longitude” LON 136° 46.3008’E
Do not touch the screen for about 10 seconds,
the information bar will be fade out.
The cursor icon is eliminable by carrying out a
double tap.
You can use the rotary knob to adjust the cursor position.
Horizontal direction: Turn the rotary knob.
・
Turn to the right. Then the cursor move to right.
・
Turn to the left. Then the cursor move to left.
Vertical direction: Turning while pressing the rotary knob.
・
Turn to the right. Then the cursor move to upward.
・
Turn to the left. Then the cursor move to downward.