163
Q
Although a connection has been established, I
cannot connect to the Internet.
▶
Check the TCP/IP settings.
A
If you cannot connect to the Internet but you are
connected to an AP, check if the TCP/IP settings are
configured properly.
When you are not connected to an AP, an X mark
appears over the ‘Wireless Network Connections’
icon (
) in the Taskbar. If you double-click the
icon, the Search for Wireless Connections window
appears. Reconnect to a wireless network referring
to the descriptions of
Connecting to a Wireless
LAN
in the Using the Network section.
When you are connected to an AP, an X mark
appears over the “Wireless Network Connections”
icon (
) in the Taskbar. Double-click the icon and
check if the IP address is properly allocated on
the Support tab. If the IP address is not properly
allocated, the IP address will be displayed as follows;
(for example, 169.254.xxx.xxx).
If your network does not support DHCP, you have
to manually configure an IP address by asking your
network administrator.
In addition, even if your network supports DHCP,
the Internet connection may not be available if the
DHCP server fails to allocate an IP address to your
computer.
Q
I have configured both wired and wireless
connections with the same IP address, but the
network connections do not work properly.
A
You cannot use the same IP address for wired and
wireless connections. To use only one IP address
for both wired and wireless connections, you must
disable one of them according to your requirements
in Network Connections in the Control Panel.
Q
After installing the Wireless LAN Setting
program, the “AEGIS Protocol (IEEE 802.1x)”
protocol appears in the [Local Area Connect
Properties] window.
A
The protocol is a security authentication protocol
that is automatically installed when the Wireless LAN
Settings program is installed and does not affect the
program operation.
Q
(For Intel PROSet) Although I have turned the
wireless LAN off using the Turn Off Wireless LAN
button in PROSet, the Wireless LAN LED is still
on.
A
This is normal. The Turn Off Wireless LAN button
in
PROSet
just turns off the wireless LAN software.
The wireless LAN hardware is not affected by this
operation.
Summary of Contents for NP-X22
Page 1: ...User Guide X22...
