Samsung ML-2950ND, User Manual

Page: 125 / 230

Wireless network setup
35 2. Using a network-connected machine
Disconnecting from a network
To disconnect the wireless network connection, press the (WPS)
button on the control panel for more than two seconds.
• When the Wi-Fi network is in idle mode: The machine is
immediately disconnected from the wireless network, and the
WPS LED is off.
• When the Wi-Fi network is being used: While the machine
waits until the current job is finished, the light blinks fast on the
WPS LED. Then, the wireless network connection is automatically
disconnected. The WPS LED is off.
15
Using the menu button
Before starting, you will need to know the network name (SSID) of
your wireless network and the network key if it is encrypted. This
information was set when the access point (or wireless router) was
installed. If you do not know about your wireless environment,
please ask the person who set up your network.
After completing the wireless network connection, you need
to install a machine driver to print from an application (see
"Installing driver over the network" on page 17).
1
Press the ( Menu ) button on the control panel.
2
Press Network > OK > Wireless > OK > WLAN Settings > OK .
3
Press the OK to select the setup method you want.
• Wizard: The wireless network interface card in your
machine searches for wireless networks in the area and
shows the results.
• Custom: You can configure the wireless settings according
to your needs.
Wizard mode
1
The wireless network interface card on your machine searches
for wireless networks in the area and shows the results.
2
Press Search List > OK > select a the network > OK .
You can select a network using SSID.
3
Press WLAN Security > OK > None > OK .
If you see another message, go to the next step.