SAMSUNG DCS
PROGRAMMING
TECHNICAL MANUAL
SECTION
Page 224 of 287
Updated I&M
May 2002
MMC 724:
Dial Numbering Plan
The following details the Ports default data for DCS 70 and DCS 24. The FEATURES listed are
applicable to DCS 24, DCS 70 and DCS 200 with Version 6 software installed. Some features do not
apply to Ver 5.XX DCS 70 or DCS 24 – these are noted accordingly.
DESCRIPTION:
Provides the access codes and dialling plan needed for operation of features and programs. The system
comes with a wide range of acceptable numbering plans set as default and the option to customise the
dialling plan. An error message is also provided in case an access/feature code is duplicated.
The following options may be selected:
0 STN DIAL NUMBER
Determines the station port dialling numbers
1 TRK DIAL NUMBER
Determines the trunk port dialling numbers.
2 STNG DIAL NUMBER
Determines the station group dialling numbers.
3 TRKG DIAL NUMBER
Determines the trunk group dialling numbers.
4 FEAT DIAL NUMBER
Determines the feature codes.
5 MISC DIAL NUMBER
Determines the miscellaneous port dialling numbers.
6 S0 STN DIAL NO.
Determines the S0 station dialling number.
7 DECT STN DIAL NO
Determines the DECT station dialling number. (Not DCS 24)
Feature codes are entered via the dial keypad, by pressing numbers as shown in the table below. For
example, for OHVA, the number 6 would be pressed three times. If Block Code is required, press 2 for
the first letter B and then use the UP or DOWN key to make the selection from BARGE to BLOCK.
Important
: Remember that this program is system wide.
DIAL KEYPAD
COUNT
→
1
2
3
DIAL 2
AAPLAY
BARGE
CAMP
DIAL 3
DICT
DICT
FAUTO
DIAL 4
GPIK
HDSET
IOG
DIAL 5
LCR
LCR
LCR
DIAL 6
MMPA
NEW
OHVA
DIAL 7
PAGE
REJECT
SETMG
DIAL 8
UA
UA
VDIAL
DIAL 9
WCOS
WCOS
WCOS
PROGRAM KEYS
UP & DOWN
Used to scroll through options
KEYPAD
Used to enter selections
SOFT KEYS
Move cursor left and right
SPK
Used to store data and advance to next MMC
HOLD
Used to clear previous entry
