Sampo Rosenlew Comia c4, Instruction Book

Page: 90 / 141

– 88 –
P18
P19
P20
‡ Slacken the table drive belt by turning lever A, ¿ g.
P18, and remove the belt off the drive pulley of the
sliding coupling shaft.
‡ Disconnect the feed cable for the table reverse
from the quick release.
‡ Place the table support in between the knife ¿ n-
gers, in the approximate centre of the knife, as
shown in
¿ g. P19.
‡ Lower the table ensuring that the support remains
in position and that the table comes away from the
crop elevator.
‡ When the crop elevator is entirely off the table,
reverse the combine, checking that the table does
not move.
CUTTING TABLE Parallel to the Ground
The widthwise position of the cutting table
can be adjusted by changing the height
of the fork brackets of the crop elevator
on both sides of the table, as follows:
‡ Lower the cutting table onto the ground.
‡ Slacken screws A and B, ¿ g. P20.
‡ Turn eccentric plate C in the required direction.
‡ After adjusting, tighten the screws.
‡ The adjustment is made on both sides of the crop
elevator.