Sampo Rosenlew Comia c4, Instruction Book

Page: 61 / 141

– 59 –
L41c
Turning and Operating of the UNLOADING PIPE
(Figs. L41c)
Switches C on the traction lever are used to swing
the unloading pipe into the unloading position. The
pipe rises by pressing the higher button and lowers by
pressing the lower button. The safety switch
K fig B2C
must be activated in its top position before swinging of
the unloading pipe.
Depending on the specification there may be a quick
operation to turn the pipe. In this case pressing one
button will turn the pipe to its extreme position. The
movement will stop if either button is pressed during
turning. Another press will turn the pipe in the required
direction.
The movement can also be stopped by depressing
SAFETY SWITCH on the instrument panel.
The switch
VKDOODOZD\VEHGHSUHVVHGZKHQGULYLQJRQWKH
road.
To release the safety switch to its top-most position,
turn the knob clockwise.
Note! buzzer will sound and the control light is on
when the unloading pipe is turning.
8QORDGLQJPD\QRWEHFRQQHFWHGXQWLOWKHSLSHLV
DOOWKHZD\XSDQGWKHFRQWUROOLJKWKDVJRQHRII
Unloading is switched on by depressing the front of
operating switch B. Unloading will stop when the rear
end of the switch is pressed.
While unloading, it must be monitored that there
LVDOZD\VHQRXJKVSDFHIRUWKHXQORDGLQJJUDLQ
beneath the top end of the pipe. The auger and the
WUDQVPLVVLRQPD\JHWGDPDJHGXQOHVVWKHJUDLQ
can unload unhampered.
All the functions mentioned above are possible with the
engine running. The threshing mechanism does not
need to be engaged.
The driver must sit on the seat in order to unloading and
the cutting table to be functional.