Sampo Rosenlew Comia c4, Instruction Book

Page: 77 / 141

– 75 –
L79
DHC
Presetting of Cutting Height
6DIHW\3UHFDXWLRQV
Always keep the equipment in good condition. Make
sure you repair any defects as soon as they appear.
Faulty equipment must not be used.
Before starting the combine, make sure the DHC se-
lection switch A is in its mid position.
Make it a rule to
FKHFNWKLVDOZD\VEHIRUHVWDUWXS
Keep in mind that when the equipment is switched on,
there is an automatic movement.
Make sure there are no people or animals within a dan-
ger zone when moving the cutting table.
Use
The DHC is a system by means of which a cutting ta-
ble is set to the preset cutting height at a short touch of
a button.
When the bottom end of selection switch A is de-
pressed all the way to the AUTO position, the system is
in its stand-by position.
DHC system can store two values in storage places.
To save the current position of the cutting table to stor-
age place, hold SHIFT button B with button C or D for
at least 2 seconds. The cutting table height value re-
mains saved until a new value replaces the old one.
To use stored cutting table height push SHIFT button B
with button C or D.