Sampo Rosenlew Comia c4, Instruction Book

Page: 49 / 141

– 47 –
L12c
L13c
Height of the CUTTING TABLE (Figs. L12c,
L13c and L14c)
(OHFWULFDOO\&RQWUROOHG$GMXVWPHQWV
Switches A, ¿ g. L12c, adjust the height.
Table lowering speed can be adjusted steplessly by
turning the knob in the control valve above the right-side
front fender. Speed increases clockwise and decreases
counter-clockwise.
Cutting height is shown on the Comvision display.
The cutting table is eased using a gas accumulator, and
the warning light is lit when pressure off the table lifting
is too low and table switched on. When warning light
is lit, the table lies heavily against the ground, in which
case soil or stones easily get onto the table and damage
it.
Adjustment of the pressure switch is done as follows:
Pressure switch is located in the output line of the
table valve
fig. L13c . Warning light must be observed
when adjusting pressure switch, table switched on.
Alternatively conductivity of the switch can be measured
with multimeter when engine not running. Warning light
is lit when switch is conductive.
1.Lift table ca.10 cm off ground
2.Turn adjusting screw clockwise until warning light is
lit
if not already litted
3.Turn adjusting screw counter-clockwise until warning
light goes off. Continue turning still yet 1 8 round
after warning light goes off.
More you turn switch open after warning light goes
off, the more heavily table is allowed to lie against the
ground before warning light is lit.
1RWH:DUQLQJOLJKWPD\EOLQNDOVRZKHQORZHULQJ
table.