Sampo Rosenlew Comia c4, Instruction Book

Page: 40 / 141

– 38 –
K22
K21b
K21
Drive the table above the trailer from the left-hand side
so that the knife is level with the trailer marking sticks
and brackets A,
¿ g K21, are between carriers B. Lower
the table slowly.
Make sure the table is positioned correctly:
Reverse slowly so that the rear end of the table is
against both the carrier limiters.
Lower the crop elevator further so that it becomes dis-
engaged from the cutting table and back up the combine
with caution. Raise the crop elevator as soon as pos-
sible.
Push the rear locking pins into their locking position. Fig.
K21.
Place the winch on the axle
fig K21b , hook the table
with the winch and tighten.
Fit the guard plate over the feeder inlet,
¿ g. K22.
Hook the trailer to the combine and plug in the electric
cable.
Attaching of the Cutting Table to the Com-
bine
is done in reverse order. In case the trailer must be
left on the road temporarily, place appropriate warning
signs.
Trailer on Tow
Extreme caution shall be exercised when towing the
trailer.
The total length of the vehicle is approx. 15 m, so turn-
ing the vehicle requires space.
Do not turn the rear wheels to their extreme position
DVWKHWUDLOHUDUPPD\WRXFKWKHUHDUZKHHODQGWKH
vehicle will get stuck.
However, if this is the case, the situation can be helped
by backing up the combine and using the steering brake
at the same time.
Reverse very carefully. Watch the trailer movements in
the mirror.