Sampo Rosenlew Comia c4, Instruction Book

Page: 8 / 141

– 6 –
A6
When servicing the hydraulics, be aware of the high pressure in the system. Make sure there is no pressure in
the system or in the pressure accumulator before disconnecting the connectors.
Never use over-sized fuses; they involve risk of accident.
Never start the combine with anything but the ignition key.
When re
¿ tting a wheel, tighten the ¿ xing screws to the correct torque.
Attach accessories such as the trailer using the appropriate equipment.
Tow the combine only from designated points.
5. THE LAWS AND REGULATIONS
Combine harvester is a complex device, and dangerous if misused. User manual must always be preserved with
the machine at the place reserved for it and if needed, new drivers should be instructed to operate the machine
Different countries have different safety at work and traf
¿ c regulations. Get to know the existing regulations of
your area.
4. REPAIR AND SERVICE
Always keep the combine in good condition.
Check the condition of fast moving parts daily. Pay
special attention to the transmission mechanism and
the rotating chopper knives. Replace defective parts
before they become dangerous.
Clean, repair and service the combine with the trans-
mission and engine off, the ignition key off the ignition
switch and the master switch in its off position.
Disconnect the negative battery cable before repairing
the engine or any electrical instruments.
Do not use inappropriate tools to connect and discon-
nect the battery.
Do not make an open
¿ re or smoke near the battery.
Handle the battery acids with care.
Do not add air in the tyres without a pressure gauge
due to risk of explosion.
Do not add coolant with the engine running.
Do not remove the radiator cap from an overheated
engine.
Do not refuel with the engine running.
Beware of hot surfaces of the engine and exhaust pipe.
Do not smoke while fuelling.
Do not adjust the hydraulic working pressure without a
pressure gauge due to possible damage to the hoses.