Samlexpower Evolution Series, Owner'S Manual

Page: 6 / 92

6 | SAMLEX AMERICA INC.
SECTION 2 | Installation
2.0 INSTALLATION GUIDELINES
EVO-RC-PLUS is provided with 10M/33ft, RJ-45 data cable (straight wired). Check the proposed
routing distance of the wire and use longer wire, if necessary.
• Flush mounting of the Remote requires appropriate cut-out in the wall/panel - See Fig 2.1.
Full scale installation Template for panel cut-out and pilot holes for mounting screws is also
provided along with the unit. Take necessary precautions to ensure any wiring/plumbing run-
ning behind the wall/panel is not damaged.
• Route the wire to ensure there are no kinks.
• Use appropriate grommets when the wire is passed through holes in studs/partitions to
prevent damage to insulation.
2.1 TOOLS REQUIRED
Following tools are recommended:
• Phillips head screwdriver
• Level • Hand Drill
• Knife/Saw • Pencil • Drill Bit (2mm /
5
/
64
")
EVO-RC-PLUS Installation Template
100 mm / 3.94 in
4.2 mm / 0.17 in
114.2 mm / 4.5 in 95 mm / 3.74 in
131 mm / 5.16 in
146 mm / 5.75 in
160 mm / 6.3 in
Cut the wall / panel along the dotted
line with a jig saw.
This will create a pocket in the wall / panel
for flush mounting the EVO-RC-PLUS.
13 mm / 0.51 in
W
ALL
Thickness of wall where
mounted should be up
to 13 mm / 0.51 in (see below).
Wall thickness
should be up to
13 mm / 0.51 in.
BOTTOM VIEW
Flush mounting the EVO-RC-PLUS
on the wall with 4 pcs of No. 6 x 5/8”,
Self-Tapping, Flat Head Screws.
A to D: 4 pilot holes, 2mm (5/64") diameter for
accepting No. 6 x 5/7", Self Tapping,
Flat Head Screws.
A
C D
B
Fig 2.1 EVO-RC-PLUS Remote installation details
2.2 FLUSH MOUNT INSTALLATION
To flush mount, the wall opening must have at least 2” (5 cm) depth to make room for the
remote and cable. Also, the thickness of wall/panel board at the place of mounting should not be
more than 13 mm to ensure that the RJ-45 / RJ-12 Jack openings are not obstructed (see Fig. 2.3).