34 | SAMLEX AMERICA INC.
SAMLEX AMERICA INC. | 35
2 digits. Hence, for EVO-1212F / 1212F-HW, the numerical value of BULK CURRENT will be
displayed /entered as 2 digits. For example, 1A will be displayed / entered as “1A”; 20A will
be displayed / entered as "20A" and so on. The overall numerical value of the parameter is
changed digit by digit starting from the 1st digit on the left. On entering the desired "Select
Parameter" Screen (Figs 4.2 to 4.5), a curser will appear under the 1
st
digit and the cursor
and the digit will be blinking. Scroll to the desired numerical value for the 1
st
digit using Up
and Down Keys. Press the Enter Key
momentarily
to write the desired numerical value for
the 1
st
digit. The curser will automatically move to the 2
nd
digit on the right. The 2
nd
digit and
the curser and the digit will be blinking. Scroll to the desired numerical value for the 2
nd
digit
with the help of Up and Down Keys. Then, press the Enter Key
momentarily
to write the
desired numerical value for the 2
nd
digit. The overall numerical value of the parameter will be
selected after scrolling to the desired numerical value for the
last digit
. Now, press the Enter
Key,
HOLD for 3 to 4 sec and then release
. Process for writing the overall numerical value
of the parameter into the memory will be initiated – the screen will display message “Writ-
ing…” followed by message “Write Success!”.
Please read Section 4.3.1 for example of programming a typical parameter – BULK CURRENT
i
INFO
1. When the numerical value for any individual digit is changed that makes the
overall numerical value of the parameter outside the programmable range, an
Exclamation Sign “!” will appear on the left of the display screen warning you
to correct the overall numerical value of the parameter to within the program-
mable range before writing the new overall numerical value of the parameter to
memory. See Tables 4.3 and 4.5 to 4.8 and Sections 4.9 and 4.10 for program-
mable ranges.
2. If, after scrolling to the desired numerical value for the last digit, the overall nu-
merical value of the parameter is out of the programmable range, the Exclamation
Sign “!” will continue to appear on the left of the display screen. If an attempt
is made to write this “out of range overall numerical value” into the memory (by
pressing and holding the Enter Key when the cursor is at the last digit), message
“Out of range!” will be displayed and the screen will go back to display the origi-
nally stored value of the parameter.
Parameter set up procedure will have to
be re-started.
3. If there is some problem in writing to the memory, message “Write failure!” will
be displayed.
Parameter set up procedure will have to be re-started
.
4.3 PASSWORD PROTECTION FOR PARAMETER CHANGE
In the factory preset (Default) condition, all parameters except Time and Date are protected
with a Password. This has been done to prevent accidental / unintentional changes of
parameter values. When the required "Select Parameter" Screen is reached and is displayed and
Enter
Key is pressed to modify the parameter value, the system will request a 4-digit Password.
The Password is 8052
. Once you
Enter
the Password correctly, you don’t need to enter the
Password again until any Key is not pressed for over 60 seconds. An example of Parameter
setting is shown at Section 4.3.1.
NOTE: Password protection may be disabled, if required
–
See Section 4.3.2.
SECTION 4 |
Parameter Setup
Summary of Contents for Evolution Series
Page 89: ...SAMLEX AMERICA INC 89 Notes...
Page 90: ...90 SAMLEX AMERICA INC Notes...
Page 91: ...SAMLEX AMERICA INC 91 Notes...
