Doc.-ID: 150903-PT08BA-TG-ExCam IPM1145-(L)_en_rev.02.docx, page 28 of 40
work and hardware performances. The same is valid for passwords,
user names, streaming profiles, or IP addresses etc. which can also be
pre-configured
5.4.1
Work preparation
Attention!
Please carry out any preoperational work carefully and in accordance
with the applicable regulations
Attention!
Depending on the zone classification, it might be necessary to obtain
a work permit/clearance!
When opening the pressure resistant enclosure (Ex d) under load, po-
tentially explosive atmosphere must be avoided by any means
For the network camera to deliver the best picture quality possible, please select the
appropriate installation place; considering the light conditions, object distance and size,
angle of view and the minimum object distance for focusing (MOD).
Use appropriate tools
Make sure you have a secure foothold
Avoid static charge
5.4.2
Opening the pressure-resistant housing
Opening the pressure resistant housing (DIN EN 60079-1: 2008) of the ExCam IPM1145-
(L) is only allowed for exchanging/extracting the SD
storage card or in case a “Hardware
Reset“ of the camera module is necessary.
All other mechanical or electrical manipulations within the Ex d housing by the user is
prohibited. Such work is only to be carried out by SAMCON Prozessleittechnik GmbH.
After completion of the work, the pressure resistant enclosure has to be tightened se-
curely again. Please be very careful and follow thoroughly the steps of this manual.
„WARNING – DO NOT OPEN IN HAZARDOUS AREA“
Note: Depending on the zone classification, it might be necessary to
obtain a work permit/clearance!
Even after disconnecting the camera from power, when opening the
pressure resistant enclosure (Ex d), potentially explosive atmosphere
must be avoided by any means or the camera has to be de-installed
and the work has to be carried out in the safe area (non-EX)!
