90 • Management Functions
SAM4s ER-900 Series Operator's & Programming Manual v.1.3
System Reports
System reports are divided into two basic categories:
X
reports, which read totals without resetting
Z
reports, which read totals and reset them to zero
Most reports are available in both categories. Some reports, such as the Cash-in-Drawer
report and the From-To PLU report are available only as
X
reports.
Some reports also provide identical but separate
period to date
reports. These reports
maintain a separate set of totals which may be allowed to accumulate over a period of days,
weeks, months, or even years.
X2
reports read period to date totals without resetting, and
Z2
reports read period to date totals and reset them to zero. Period to date totals are updated
each time a
Z1
report is completed.
A complete list of available reports is presented in a chart on the following page.
See “Sample Reports” on page 203 for an example of each report.
Registers programmed with pop-up clerks must be signed on in the
REG
control lock
position prior to taking reports.
Running a Report – General Instructions
1.
Refer to the “Report Table” on the following page.
2.
Select a report type and the report mode.
3.
Turn the control lock to the position indicated.
4.
Enter the key sequence for the report you have selected.
Summary of Contents for ER-900 Series
Page 10: ...10 Introduction SAM4s ER 900 Operator s Programming Manual prelim ...
Page 20: ...20 Introduction SAM4s ER 900 Series Operator s Programming Manual v 1 3 ...
Page 34: ...34 Getting Started SAM4s ER 900 Series Operator s Programming Manual v 1 3 ...
Page 116: ...116 S Mode Programming SAM4s ER 900 Series Operator s Programming Manual v 1 3 ...
