Saluki S3601 Series, User Manual

Page: 66 / 140

66
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
set up:

Current Stimulus marker

stimulus value of Stimulus marker
 △
marker, carry out maximum/minimum value search, and set up start/stop and center/span stimulus value of the
Analyzer according to the marker position.
When the marker tool bar is enabled, if you want to change the position of Stimulus marker by the knob on the front panel, firstly click
[Stimulus] frame in the marker tool bar, and then turn the knob to change the marker position, referring to Section 1 “Marker” in
Chapter VIII for detailed information about marker.

Measure tool bar
The Measure tool bar is used to create required S parameter Trace in the current Stimulus window or new window, create S
parameter Trace in the current Stimulus window when the leftmost button in the Measure tool bar is uplifted (
), and create S
parameter Trace in the new window when the button is pressed down ( ).

Sweep control tool bar
Buttons on the sweep control tool bar respectively set up the trigger way of the Stimulus channel to be:

Hold mode

Single Sweep, and then enter into Hold mode

Continuous Sweep

Stimulus toolbar
The Stimulus toolbar is used to observe and set up sweep activation, and it is able to set up:

Start stimulus value

Stop stimulus value

Sweep spot number

Time domain toolbar
The following settings can be carried out by using the time domain toolbar:

Enable or stop the time domain transformation and the time gate functions.

Change settings of start/stop or center/span of the time domain transformation and the time gate time.

Click [More…] button to open the Time Domain Transformation dialog box.

Click [X] button to close the time domain toolbar.

Close all menus
Click [All OFF] menu, and all toolbars can be closed once.