salmson IXENS, Installation And Starting Instructions, Page: 135 / 336

English
Installation and operating instructions Ixens, Ixens Bloc 127
12 Spare parts
Spare parts may be ordered via a local specialist and/or Samson cus-
tomer service.
When ordering spare parts, make sure to state all the information
given on the pump and drive rating plates (for the pump rating plate,
see Fig. 11, Item 1, for the drive rating plate, see Fig. 12, Item 3)
. This
helps prevent return queries and incorrect orders.
CAUTION! Risk of property damage!
Trouble-free pump operation can only be guaranteed when origi-
nal spare parts are used.
• Only use original Salmson spare parts.
• Each component is identified in the table below.
• Information to be provided when ordering spare parts:
• Spare part number
• Name/description of the spare part
• All data on the pump and drive rating plates
NOTE:
For a list of original spare parts, see the Salmson spare parts docu-
mentation (www.salmson.com). The item numbers on the exploded
view drawing (Fig. 7) are intended as orientation and to provide a list
of the pump components (see list “Tab. 2: Arrangement of the main
components” on page 76). These item numbers are not to be used to
order spare parts.
13 Factory settings
For the factory settings, see Tab. 13 below.
Menu
no. Designation Factory-configured values
1.0.0.0 Setpoints • Controller:
approx. 60 % of n
max
pump
• Δ p-c:
approx. 50 % of H
max
pump
• Δ p-v:
approx. 50 % of H
max
pump
2.0.0.0 Control mode Δ p-c activated
3.0.0.0 Δ p-v gradient Lowest value
2.3.3.0 Pump ON
4.3.1.0 Base-load pump MA
5.1.1.0 Operating mode Main/standby operation
5.1.3.2 Internal/external pump
cycling
Internal
5.1.3.3 Pump cycling time interval 24 h
5.1.4.0 Pump enabled/disabled Enabled
5.1.5.0 SSM Collective fault signal
5.1.6.0 SBM Collective run signal
5.1.7.0 External off Collective external off
5.3.2.0 IN1 (value range) 0–10 V active
5.4.1.0 IN2 active/inactive OFF
5.4.2.0 IN2 (value range) 0–10 V
5.5.0.0 PID parameter See chapter 9.4 “Setting the con-
trol mode” on page 110
5.6.1.0 HV/AC HV
5.6.2.0 Emergency operation speed approx. 60 % of n
max
pump
5.6.3.0 Auto reset time 300 s
5.7.1.0 Display orientation Display on original orientation
5.7.2.0 Pressure value correction Active