salmson IXENS, Installation And Starting Instructions, Page: 110 / 336

English
102 Salmson 05/2015
NOTE:
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment under menu number
<5.4.1.0> is set to “OFF”, the number <5.4.2.0> will be hidden. Menu
number <5.4.2.0> will only be visible if menu number <5.4.1.0> has
been set to “ON”.
No. Designation Type Symbol Values/explanations Display conditions
1.0.0.0 Setpoint Setting/display of the setpoint
(for further information, see
chapter 8.6.1 “Adjusting the
setpoint” on page 98)
2.0.0.0 Control mode Setting/display of the control
mode
(for further information, see
chapters 6.2 “Control modes” on
page 78 and 9.4 “Setting the
control mode” on page 110)
Constant speed control
Constant control Δ p-c
Variable Δ p-v control
PID control
2.3.2.0 Δ p-v gradient Setting the gradient of Δ p-v
(value in %)
Not displayed for all pump
types.
3.0.0.0 Pump on/off ON
Pump switched on
OFF
Pump switched off
4.0.0.0 Information Information menus
4.1.0.0 Actual values Display of current actual values
4.1.1.0 Actual values sen-
sor (IN1) Depending on current control
mode
Δ p-c, Δ p-v: Value H in m
PID control: Value in %
Not displayed for manual
control mode
4.1.3.0 Power Current power input P
1
in W
4.2.0.0 Operating data Display of operating data The operating data refer to
the electronic module cur-
rently being operated
4.2.1.0 Operating hours The pump's total active operat-
ing hours (counter can be reset
via the infrared interface)
4.2.2.0 Consumption Energy consumption in
kWh/MWh
4.2.3.0 Countdown, pump
cycling Time to pump cycling in h (at a
resolution of 0.1 h) Shown only for double pump
master and internal pump
cycling Can be set in the ser-
vice menu <5.1.3.0>
±
±
±